Eval Flex Cable Based Thermal Validation System

Eval-Flex-

Thermal Validation System
The E-Val Flex thermal validation system is designed for validation applications that require compliance with FDA guidelines and international GMP standards. The E-Val Flex greatly simplifies and correctly documents the entire validation process. The ValSuite™ software keeps a complete database on all aspects of your validation requirements – tracking thermocouples, calibration reports, test setup, data analysis, specific user access, to final compliance reports.

Flexibility For Different Validation Applications
E-Val Flex was designed as a single solution for all thermal validation applications. It can be ran as a stand-alone unit or networked with your PC. The software, which handles up to 128 channels, documents and controls each step reducing errors and maintaining guidelines for more complex regulated applications that require tight compliance control. The easy expandability makes this a complete validation solution for a facility with a variety of applications.

Quality
The highest quality electronics were incorporated into the design greatly improving efficiency and accuracy. With 8MB of memory and a battery backup, data will never be lost due to a power outage. Pt-1000 sensors are installed on each individual thermocouple channel eliminating gradient errors through the cold junction dramatically improving accuracy. The case is made in 316 stainless steel ensuring durability and reducing noise in the electronics which makes the unit ideal for the harsh environments on a factory floor.

Accuracy
Dramatic improvements in accuracy with enhanced engineering:
Pt-1000 sensors are installed on each individual thermocouple channel eliminating gradient errors through the cold junction
Implementation of ID chips enabling factory certification and storage of calibration offsets in each individual thermocouple
Use of high quality sealed thermocouples

The E-Val Flex system reduces the need for frequent calibration saving a tremendous amount of time. Competitive systems require calibrations before every study. We recommend running a one point verification test to find any damaged or degraded thermocouples. If you need to replace a damaged thermocouple a system calibration is not required. Since the Ellab type T thermocouples are pre-calibrated and hold the offsets in the ID chip, a 0.05°C accuracy is held.